Yanggu Jixing Drilling Tools Co.,Ltd
Contact US
Address: No.311,Qinghe West Rd.,Yanggu County,Liaocheng City,Shandong Prov.,China.
Manager: Angelia
TEL: 86-635-2959777
FAX : 86-635-6382558
Home > News > Content
Band Saw Blade BEng Tooth Causes And Solutions
- Nov 14, 2016 -

Disintegrating teeth causes
Excessive cutting feed
Wire brush features not used
Cutting fluid is too small
Saw tooth spacing is too small
Zigzag card and materials when cutting release material on the corner of
Cut squares, cylindrical material towards the end, cut too much load increases dramatically sawed with a nod
Solution:
Adjust feed
To replace the wear oversized, make adjustments to the position of
Increased cutting fluids, adjust the nozzle into position
Changing the saw blade pitch, or reduce the feed rate, paying particular attention to large diameter solid material
For-tooth small band saw blade, tilted square material clamping or decrease the feed
Paying particular attention to the level of pin-type machine that changed pitch a large band saw blades, or decrease the feed
Paying particular attention to hinge the machine, it is necessary to confirm the adjustment tube partial-wear of the pulley, arm relaxed and saw blade core out of the situation, and make the necessary adjustments